How to Install the Profile

Your device version is
Please follow the steps below to install the profile

Click Allow

security 0

Will ask your device password or face iD

This message is due to Apple's new updates to increase the protection of devices from theft, but it conflicts with installing the profile and causes a lot of delay. It is better to turn it off..

security 1


If you do not receive a security delay message, click here to go to the explanation of installing the profile



Click OK

security 2

Open Settings

security 3

Click on Face ID and Passcode

security 4

Enter your device password

security 5

Scroll down and click on Stolen Device Protection

security 6

turn off Stolen Device Protection

security 7

You must wait one hour, then go back again and turn off the stolen device protection

security 8

You will receive an alert notification after one hour, then go to settings and apply the same steps above again and turn off the stolen device protection, but you must not delay because if you delay, you will have to wait another hour

security 9




To install the profile after you turn off the security delay, refresh the page to complete and install profile

Step 1: Tap Allow

step 1

Step 2: Tap Close

Step 2

Step 3: After closing settings from background, re-open it again

(Close the settings from background to avoid conflicts)

Step 3

Step 4: Tap on "Profile Downloaded"

If you don't see it, go to General, then VPN & Device Management to install the profile
Step 4

Step 5: Tap "Install" on the top-right corner

(If you see a red warning saying 'Unsigned' or 'Not Verified', it's routine from Apple, just continue)

Step 5

Step 6: Enter your device passcode if asked

Step 6

Step 7: Tap "Install" on the top-right corner

(Don't worry about the warning, it's routine from Apple)

Step 7

Step 8: Confirm by tapping "Install" again

Step 8